|
Crown IQ3USP3 Module IQ-PIP-USP3 is a DSP-based IQ-PIPT module that integrates into a 100-Mb Ethernet network via TCP/IQ® protocol. An extremely versatile speaker-processing unit that mounts right in your Crown amplifier, this compact module greatly reduces the costs of typical audio systems while eliminating the rack space needed for signal processing. Offers up to thirty-two filters per channel as well as load supervision that continuously monitors the load impedance using the signal source as the test signal. Also includes compressors, limiters, error reporting, ten internal presets, up to 2 seconds of delay per channel, and noise and sine-wave generators. Also includes line voltage monitoring when installed in Crown CTs series amplifiers. Requires FREE IQwicT Software and a computer for initial setup. Features: 100Mb Ethernet single-plug solution for TCP/IQ control and monitoring Listen Bus amplifier output monitor 24 bit conversion with 32 bit, floating point DSP processing 64 assignable filters with 9 different filter types including all-pass filters Over 2 seconds of delay available per channel Input compressors and output limiters for each channel Dual, uncorrelated noise generators for noise masking Sine-wave generator Load supervision Full error reporting Firmware upgrades via the network 10 user selectable presets Reliable FLASH memory backup of all parameters Three Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications.
|
